Tripp Lite SMX2200XLRT2UN SmartPro 230V 2200VA 1920W Line-Interactive Sine Wave UPS 2U Extended Run WEBCARDLX LCD USB DB9
$1,721.36
Manufacturer:Eaton / Tripp Lite
Model:SMX2200XLRT2UN
Condition:New
Availability:In Stock
Condition:New
Availability:In Stock
- Power Protection
- Eaton / Tripp Lite
- UPS System
- SMX Series
- UPS Battery Backup
- Tripp Lite SMX2200XLRT2UN SmartPro 230V 2200VA 1920W Line-Interactive Sine Wave UPS 2U Extended Run WEBCARDLX LCD USB DB9
Datasheet
The Tripp Lite SMX2200XLRT2UN SmartPro UPS provides reliable battery backup and surge protection for connected devices. Delivering 2200VA/1920W of pure sine wave output at 230V this 2U rack/tower mountable UPS offers extended runtime capabilities to keep critical systems operational during power outages. The intuitive LCD interface provides detailed status information.
Equipped with USB and DB9 communication ports as well as compatibility with Tripp Lite's WEBCARDLX (sold separately) the SMX2200XLRT2UN allows for advanced monitoring and management. This makes it ideal for servers networking equipment and other sensitive electronics in demanding applications.
| APPLICATIONS | |
| UPS Applications | Large Network; High-End Desktop/Small Network |
| COMMUNICATIONS | |
| Communications Cable | USB DB9 and EPO cabling included |
| Communications Interface | DB9 Serial; EPO (emergency power off); Pre-installed network card; Slot for SNMP/Web interface; USB (HID enabled) |
| Network Management Card Description | Network management card included |
| Network Monitoring Port Description | Supports detailed monitoring of UPS and site power conditions |
| PowerAlert Software | For local monitoring via the UPSs built-in communication ports download PowerAlert software at https://tripplite.eaton.com/products/power-alert |
| WatchDog Compatibility | Supports Watchdog application OS and hard-reboot restart options for remote applications |
| DETAIILS | |
| Manufacturer | Tripp Lite |
| Manufacturer Part Number | SMX2200XLRT2UN |
| FEATURES & SPECIFICATIONS | |
| Cold Start (Startup in Battery Mode During a Power Failure) | Cold-start operation supported |
| Green Energy-Saving Features | Greater than 95% efficiency - GREEN UPS; Individually controllable load banks |
| Grounding Details | Back panel grounding lug |
| High Availability UPS Features | Auto Probe Monitoring and Reboot (included); Automatic Voltage Regulation (AVR); Hot swappable batteries; Remote management; Surge/noise protection |
| LINE / BATTERY TRANSFER | |
| High Voltage Transfer to Battery Power (Setpoint) | 278V |
| Low Voltage Transfer to Battery Power (Setpoint) | 158V |
| Transfer Time | 6 ms. (AC to DC) / 1 ms. (DC to AC) |
| OVERVIEW | |
| UPC Code | 037332256430 |
| UPS Type | Line-Interactive |
| STANDARDS & COMPLIANCE | |
| Product Certifications | GOST (Russia) |
| Product Compliance | RoHS; CE (Europe) |
| SURGE / NOISE SUPPRESSION | |
| AC Suppression Joule Rating | 350 |
| AC Suppression Response Time | Instantaneous |
| EMI / RFI AC Noise Suppression | Yes |
| USER INTERFACE ALERTS & CONTROLS | |
| Alarm Cancel Operation | Power-fail alarm can be temporarily silenced using alarm-cancel switch; silent mode alarm configuration option available |
| Audible Alarm | Audible alarm indicates UPS startup power-failure low-battery overload UPS fault and remote shutdown conditions |
| Front Panel LCD Display | Front panel LCD information and configuration screen offers detailed UPS and site power status and operating data plus configuration of voltage operating mode alarm function and a variety of additional options (see manual for detailed LCD configuration and monitoring options) |
| Switches | 3 pushbutton switches control OFF / ON power status MODE selection and MUTE / ENTER control functions |
| VOLTAGE REGULATION | |
| Overvoltage Correction | Voltage reduction of 12% applies when input is between 244-278V |
| Severe Undervoltage Correction | Voltage boost of 24% applies when input voltage is between 158-182V |
| Undervoltage Correction | Voltage boost of 12% applies when input voltage is between 183-206V |
| Voltage Regulation Description | Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 158 to 278 |
| Battery | |
| Battery Access | Front panel battery access door |
| Battery Recharge Rate (Included Batteries) | Less than 4.5 hours from 10% to 90% (typical full load discharge) |
| Battery Replacement Description | Hot-swappable user replaceable batteries |
| DC System Voltage (VDC) | 48 |
| Expandable Runtime | Yes |
| Runtime Full Load (min.) | 5 min. (1920W) |
| Runtime Half Load (min.) | 11.9 min. (960W) |
| Battery Type | Valve Regulated Lead Acid (VRLA) |
| Details | |
| Category | UPS System |
| Environmental | |
| AC Mode BTU / Hr. (Full Load) | 161 |
| AC Mode Efficiency Rating (100% Load) | 98% |
| Audible Noise | 45 dBA maximum front side 1m |
| Operating Temperature Range | 32 to 104F (0 to 40C) |
| Relative Humidity | 0-95% non-condensing |
| Storage Temperature Range | 5 to 122F (-15 to 50C) |
| Input | |
| Input Circuit Breakers | 15A |
| Input Phase | Single-Phase |
| Maximum Input Amps | 11 |
| Nominal Input Voltage(s) Supported | 230V AC |
| Rated input current (Maximum Load) | 10.7A |
| UPS Input Connection Description | IEC320-C20 input connection accepts a variety of detachable cordsets to match country or site-specific wall receptacles |
| UPS Input Connection Type | C20 inlet |
| Output | |
| Frequency Compatibility | 50 / 60 Hz |
| Frequency Compatibility Details | Automatic frequency selection |
| Hot-Swap PDU options | PDUBHV20 (2U / 6 C13 2 C19 outlets) |
| Included Output Power Cables | Includes 3 C13 to C14 output power cables |
| Individually Controllable Load Banks | Yes |
| Load Management Receptacles | Two switchable single-outlet C13 load banks |
| Nominal Output Voltage(s) Supported | 220V; 230V; 240V |
| Nominal Voltage Details | 230V nominal output in battery mode |
| Output AC Waveform (AC Mode) | Sine wave |
| Output AC Waveform (Battery Mode) | Pure Sine wave |
| Output Capacity (kVA) | 2.2 |
| Output Capacity (kW) | 1.92 |
| Output Capacity (VA) | 2200 |
| Output Capacity (Watts) | 1920 |
| Output Receptacles | (8) C13 |
| Output Voltage Regulation (Battery Mode) | +/- 5% |
| Output Voltage Regulation (Line Mode) | -15% +6% |
| Power Factor | 0.87 |
| Physical | |
| Cooling Method | Fan |
| Installation Form Factors Supported with Included Accessories | 4 post 19 inch rackmount |
| Minimum Required Rack Depth (cm) | 58.42 |
| Minimum Required Rack Depth (inches) | 23 |
| Minimum Required Rack Depth with External Battery Pack (cm) | 67 |
| Minimum Required Rack Depth with External Battery Pack (in.) | 26.5 |
| Minimum Required Rack Depth without External Battery Pack (cm) | 55 |
| Minimum Required Rack Depth without External Battery Pack (in.) | 21.75 |
| Mounting Details | Included 4POSTRAILKIT mounting bracket enables installation in 4 post racks from 20.5 to 36 inches (521 to 914mm) |
| Primary Form Factor | Rackmount |
| Primary UPS Depth (mm) | 495 |
| Primary UPS Height (mm) | 89 |
| Primary UPS Width (mm) | 445 |
| Shipping Dimensions (hwd / in.) | 8.70 x 24.20 x 21.50 |
| Unit Weight (kg) | 31.18 |
| Unit Weight (lbs.) | 68.750 |
| UPS Housing Material | Steel |
| UPS Power Module Dimensions (hwd in.) | 3.50 x 17.50 x 19.50 |
| UPS Power Module Weight (kg) | 31.18 |
| UPS Power Module Weight (lbs.) | 68.75 |
| Rack Height | 2U |
| Shipping Weight (kg) | 36.76 |
| Warranty | |
| Warranty/Returns | 30 Days |